P0735 — Gear 5 — incorrect ratio
Reference detail for fault code P0735 on the 09E transmission.
What P0735 indicates
The 09E transmission control unit stores P0735 when it detects the following condition: Gear 5 — incorrect ratio. This is a mechanical plausibility check: the control unit compares the input and output shaft speeds with the ratio expected for the selected gear. The code is stored when the calculated ratio does not match or a gear drops out unexpectedly. A stored code does not by itself prove that a part has failed. Before replacing anything, check the live data, wiring, connectors, power supply and fluid condition, and confirm the fault on the vehicle.
Symptoms
- Engine revs flare without acceleration
- Gear drops out or the transmission stays in one gear
- Emergency mode
- Transmission warning light
Possible causes
- Clutch or brake slip inside the transmission
- Hydraulic pressure fault in the mechatronic unit
- Faulty input or output speed sensor
- Internal mechanical damage
Related components
Speed sensors · Clutches / brakes · Mechatronic unit · Gear set or variator
| Fault code | P0735 |
|---|---|
| Transmission | 09E (6-speed automatic (Tiptronic)) |
| Factory code | 0B6 / 09E / 09L |
| Category | Gear ratio / gear loss |
| Status | Documented — review advised |
This code is documented but not independently confirmed. Confirm it against the specific vehicle before ordering any part.
Generic OBD-II transmission code (SAE J2012). The meaning is standard; the cause on this transmission should be confirmed by diagnosis.
Have this code on your vehicle?
Send us the code and the vehicle details and we will confirm the correct unit or part by email.
Have a fault code to check?
Send us the code and the vehicle details and we will confirm the correct unit or part by email.